Yamaha Grizzly Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
116 Posts
Discussion Starter #1
I just got my 8 more Moose wheel spacers and the 2 inch Billet Power Tip and it looks awesome.

I can't wait to install them!

I'm still waiting on the Pro Design Pro Power Flow Kit to come in.

I sold my K&N air filter on Ebay for $41.51!

I just shipped today!
 

·
Registered
Joined
·
1,337 Posts
Master400, don't forget to drill some holes in your baffle before fitting the 2 inch Billet Power
 

·
Registered
Joined
·
116 Posts
Discussion Starter #4
why should I drill holes in it?
 

·
Registered
Joined
·
116 Posts
Discussion Starter #5
I just installed it and it does great!

It sounds a lot better and has a little more horsepower!
 

·
Registered
Joined
·
1,337 Posts
What the guys do (see old posts) is take a very long drill bit about 12mm diameter and drill 6-8 holes through both baffles, this increase the airflow, gives you some power and makes you griz louder. It sounds so sweet!! if you go 12 holes it sounds like a Raptor 600 with a GYTR pip on it!!
 

·
Registered
Joined
·
1,337 Posts
take a look at http://www.sa750.com/exhaust/exhaust.htm it is not a grizzly exhaust but the principle is the same.
 

·
Registered
Joined
·
1,337 Posts
Hi,

The Griz has 2 bafles about 35cm apart.

(personally I removed everything inside my exhaust canister other than the spark arrestor. But that makes it VERY LOUD!!)
 
1 - 10 of 10 Posts
Top