Yamaha Grizzly Forum banner

1 - 5 of 5 Posts

·
Premium Member
Joined
·
620 Posts
Discussion Starter #1
Does anybody know what wires to cut or modify to eliminate the reverse and diff-lock limiters?

I think I may create an FAQ or Tech section on this site to house this information... sorta like a knowledgebase.

Rob
 

·
Registered
Joined
·
16 Posts
The Green wire with the white tracer that goes along the top of the frame just above the pul cord. If it is grounded it bypasses the limiter. wire it as you see fit. I have seen it permanately grounded and I have seen a toggle switch installed as well.
Good luck.
 

·
Registered
Joined
·
4 Posts
For the 02 - 03 ONLY.

The white wire at the CDI is the Diff-Lok Limiter. Cut it to override.

White with green stripe is for Reverse Limiter. Ground it to override.

The 04 is much easier to override the reverse limiter.

I have schematics and pics posted, look in my profile for a link.

:)
 

·
Registered
Joined
·
3 Posts
Grizzhopper,
Thanks for the schematics for the overrides. I'm new to this site and to ATV's, just bought an '04 Camo Grizz. I wired the reverse override into the lock override button and it works great! I've found its a bit irritating to not have full power in reverse to get back out of the snowbank.
 
1 - 5 of 5 Posts
Top