Yamaha Grizzly Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
I torn my left front outer CV boot and have ordered a replacement boot. This is on an '04 Grizzly 660. Does anyone have any detailed instructions of how to do this? Pictures/diagrams would be great if there are already posted somewhere as a "how to" post.
Thanks for your help in advance. I'm planning on taking on this task this weekend.
 

·
Registered
Joined
·
1,337 Posts
Highmark take a look here..

http://www.atvtires.ca/REBUILDING%20TECHNIQUES.htm

I hope this helps!
 

·
Registered
Joined
·
5 Posts
Discussion Starter #3
Thanks for the link, "The Beast".
Do I have to take all that apart to replace the outside boot? Do I have to slip on the boot from the inside side of the half-shaft?
Should I take the whole A-arm off or just the top or bottom.
Thanks again!
 

·
Registered
Joined
·
1,337 Posts
Highmark00, I have not done the job myself, I did see parts of it done by a Yamaha Mechanic, If I remember correctly you can slip the boot over, not sure though. I had seen the link previously so I thought it may help!
 
1 - 4 of 4 Posts
Top