Yamaha Grizzly Forum banner

Parts I Just Ordered

2K views 8 replies 4 participants last post by  starky 
#1 ·
I ordered Maier Black Handguards $45, Pro Design Pro Flow Filter kit $111 & 2 inch power tip $48.

This should make a difference in power output & horsepower!

It should sound cool also with the power tip and & air lid off with the Pro Design Pro Flow Filter Kit!

Later I will try to sell my stock tire and buy 25 inch Maxxis Bighorn Radials for $335 but I will not buy the ITP C-Series rims because they cost way too much!

I'll just use the stock rims.
 
#3 ·
I think the rims cost $95 bucks each, OUCH!

So just the ITP C-Series rims would be close to $400!

TOOOOO MUCH!
 
#4 ·
I found out how much they are!

Not quite as expensive as I thought!

$270.00 for the cheapest set of ITP, four rims, chrome lugs and chrome center caps!

$392.00 for the most expensive set of ITP, four rims, chrome lugs and chrome center caps!

Plus free shipping at ATV TIRES PLUS! AWESOME!

I might think about buying them now!
 
#5 ·
get them ****, after they're on and you're sittin back when a coldie in hand admiring how cool your machine looks you'll forget all about the money.

I saw a set at the dealer where I bought my Grizz, they were installed on a green '06...really looked good. I'll have em hopefully before the year is out.

I think I heard 8 hun for the set was about normal.
 
#6 ·
Master, If you take your airbox lid off you are definately going to have to re-jet your carberator or you will be way lean and it won't run for crap. With the lid on you will be ok.
 
#7 ·
I like the new 14" wheels ITP came out with, the series C7 or something like that. With 27" Mudlites XL radials. That's what I am planning on getting with I have won enough at the casinos in Tunica.

The Yammy dealers around here are wanting $899 (plus or minus) for the 27" ITP 589's on ITP type C4 wheels.

You can find that cheaper on the net or Ebay.
 
#8 ·
You really think I will have to re-jet if I take the airbox lid off???

I will have the Pro Design Pro Filter Kit installed when it is shipped to me!

Also I will have that 2 inch Power Tip installed when it is shipped to me!

I know the Grizzly runs a little rich, I thought with these aftermarket parts installed it would make the Grizzly run just right!

If I will have to re-jet I'll just leave the airbox lid on then!

No big deal!
 
#9 ·
Yes, you would be increasing your airflow by a group with no more fuel flow. It would probably run ok up to about half throtle. After that it will start missing and poping. Does it sound like I'm talking from experience?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top