[Amans271]

Hey everyone need some help. I have a 99 griz 600. Just got done changing over all my brakes. Took the bike out for a test run to make sure they were set up fine. Took my little guy around the yard a few times and parked back in thd garge. Go back out 45 minutes later and it wont start. Turn the key and all i can hear is clicking noise from the back of the bike

 

[Dirtco]

Follow the power from key to starter where does it stop?

 

[Layne Hedrick]

You probably left your switch on and the batteries dead. Check that out 1st.

 

[jbheugly]

I have a ' 99 Grizz 600. The "clicking" noise is the starter solenoid located underneath the left rear fender. You need a new one, that is if you have a good battery. I suspect the starter solenoid. Good luck!

 

[CWAL]

Hey everyone need some help. I have a 99 griz 600. Just got done changing over all my brakes. Took the bike out for a test run to make sure they were set up fine. Took my little guy around the yard a few times and parked back in thd garge. Go back out 45 minutes later and it wont start. Turn the key and all i can hear is clicking noise from the back of the bike

Check float level using a clear tube attached to bowl drain. (manometer)

If thats good, remove carb and check the jet needle clip on the diaphragm. Mine is on the 3rd groove but I have a aftermarket carb.